Canon NP6251 Service Manual page 485

CHAPTER 9 INSTALLATION
Step
15 Set appropriate settings for the
standard mode to suit the needs of
the user in user mode and service
mode (*5*). (Press the Reset key
twice to end service mode.)
16 Remove the door switch actuator, and
install the door tape (door stopper);
then, close the front door.
17 Clean up the area around the
machine.
18 Move the machine to the site of
installation, and adjust the two
adjusters.
19 As necessary, turn ON the drum
heater switch (by pushing it on the
right side) to suit the environment.
20 Store away the grip after removing it
from the front of the pick-up side
under the grip of the rear of the pick-
up side.
Install the four covers (3 large, 1
small) of the grip assembly.
21 As necessary, install the accessories
(sorter, etc.) according to their
respective Installation Procedure.
22 Fill out the Service Sheet.
9-30
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
For service mode (*5*), see p. 11-246.