Error Handling; Default Configuration - Cisco 350 Series Administration Manual

Managed switches
Hide thumbs Also See for 350 Series:
Table of Contents

Advertisement

Smartport

Error Handling

NOTE
Error Handling

Default Configuration

Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
changed unless Auto Smartport detects an attaching device with a different Smartport type. If
the Persistent status of an interface is disabled, the interface reverts to the default Smartport
type when the attaching device to it ages out, the interface goes down, or the device is
rebooted. Enabling Persistent status on an interface eliminates the device detection delay that
otherwise occurs.
The persistence of the Smartport types applied to the interfaces are effective between reboots
only if the running configuration with the Smartport type applied at the interfaces is saved to
the startup configuration file.
When a smart port macro fails to apply to an interface, you can examine the point of the failure
in the
Interface Settings
corrected from the
Interface Settings
Smartport is always available. By default, Auto Smartport is enabled by Auto Voice VLAN,
relies on both CDP and LLDP to detect attaching device's Smartport type, and detects
Smartport type IP phone, IP phone + Desktop, Switch, and Wireless Access Point.
See
Voice VLAN
for a description of the voice factory defaults.
page and reset the port and reapply the macro after the error is
page.
11
203

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents