Default Gvrp Configuration; Gvrp Configuration Guidelines; Configuring Gvrp - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Default GVRP Configuration

Default GVRP Configuration
Table 13-1
Table 13-1 GVRP Default Configuration
Feature
GVRP global enable state
GVRP per-trunk enable state
GVRP dynamic creation of VLANs
GVRP registration mode
GVRP applicant state
GARP timers
1. STP = Spanning Tree Protocol

GVRP Configuration Guidelines

Follow these guidelines when configuring GVRP:
•
•
•
•

Configuring GVRP

These sections describe how to configure GVRP:
•
•
•
•
•
•
•
•
•
•
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
13-2
shows the default GVRP configuration.
You can configure the per-port GVRP state only on 802.1Q-capable ports.
You must enable GVRP on both ends of an 802.1Q trunk link.
The GVRP registration mode for VLAN 1 is always fixed and is not configurable. VLAN 1 is always
carried by 802.1Q trunks on which GVRP is enabled.
When VTP pruning is enabled, it runs on all GVRP-disabled 802.1Q trunk ports.
Enabling GVRP Globally, page 13-3
Enabling GVRP on Individual 802.1Q Trunk Ports, page 13-3
Enabling GVRP Dynamic VLAN Creation, page 13-4
Configuring GVRP Registration, page 13-5
Sending GVRP VLAN Declarations from Blocking Ports, page 13-6
Setting the GARP Timers, page 13-6
Displaying GVRP Statistics, page 13-7
Clearing GVRP Statistics, page 13-8
Disabling GVRP on Individual 802.1Q Trunk Ports, page 13-8
Disabling GVRP Globally, page 13-8
Chapter 13
Default Value
Disabled
Disabled on all ports
Disabled
normal, with VLAN 1 set to fixed, for all ports
normal (ports do not declare VLANs when in the
1
STP blocking state)
Join time: 200 ms
•
Leave time: 600 ms
•
• Leaveall time: 10,000 ms
Configuring GVRP
78-12647-02