Configuring Port Error Detection - Cisco WS-C6506 Software Manual

Setting the Port Configuration
This example shows how to enable an automatic module shutdown on a module:
Console> (enable) set module autoshut enable 2
This example shows how to disable an automatic module shutdown on a module:
Console> (enable) set module autoshut disable 2
This example shows how to set the threshold of the number of times that the module can reset itself:
Console> (enable) set autoshut frequency 4
This example shows how to set the period (in minutes) over which the frequency is valid:
Console> (enable) set autoshut period 3
This example shows how to clear the run-time counters on a specific module:
Console> (enable) clear autoshut counters 3
Automatic shutdown counters cleared for module 3
Console> (enable)
This example shows how to reset the automatic module shutdown frequency to the default setting:
Console> (enable) clear autoshut frequency
This example shows how to reset the automatic module shutdown period to the default setting:
Console> (enable) clear autoshut period
This example shows how to display the automatic module shutdown configuration and current status
information:
Console> (enable) show autoshut
AutoShut Frequency:
AutoShut Period:
Mod Autoshut Current
num status
--- -------- -------- ------ ---------------- -------------------------
1
2
3
4
Console> (enable)

Configuring Port Error Detection

All ports in an EtherChannel should have the same port error detection settings.
Note
To enable or disable port error detection on a port, perform this task in privileged mode (the default port
setting for inerrors, RXCRC, and TXCRC is disabled):
Task
Step 1 Enable or disable port error detection on a port.
Step 2
Verify the port configuration.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
4-16
Chapter 4
3 times
5 minutes
Number Reason for last Time of last reset
status resets reset
NA ok -
enabled shutdown 4
disabled ok 0
enabled ok 1
Configuring Ethernet, Fast Ethernet, Gigabit Ethernet, and 10-Gigabit Ethernet Switching
- -
inband failure Mon Jul 14 2003, 22:55:45
None -
scp failure Mon Jul 14 2003, 21:03:17
Command
set port errordetection mod/port {inerrors |
rxcrc | txcrc} {disable | enable}
show port errordetection [mod | mod/port]
OL-8978-04