Cisco WS-C6506 Software Manual page 57

Chapter 2 Command-Line Interfaces
Task
Step 1
If you are in the switch CLI, enter
the MSFC CLI.
Step 2 At the EXEC prompt, enter enable
mode.
Step 3 At the privileged EXEC prompt,
enter global configuration mode.
Step 4 Enter the commands to configure
routing.
Step 5 Exit configuration mode.
Viewing and Saving the Cisco IOS Configuration
To view and save the configuration after you make changes, perform this task:
Task
Step 1
View the current operating
configuration at the privileged
EXEC prompt.
Step 2 View the configuration in
NVRAM.
Step 3 Save the current configuration to
NVRAM.
Bringing Up an MSFC Interface
In some cases, an MSFC interface might be administratively shut down. You can check the status of an
interface using the show interface command.
In a redundant supervisor engine setup, if an interface on one MSFC is shut down, the matching VLAN
Note
interface on the redundant MSFC will stop forwarding packets. Therefore, you should manually shut
down the matching interface on the redundant MSFC.
To bring up an MSFC interface that is administratively shut down, perform this task in privileged mode:
Task
Step 1
Specify the interface to bring up.
Step 2
Bring the interface up.
Step 3
Exit configuration mode.
OL-8978-04
Command
Console> switch console [mod]
Router> enable
Router# configure terminal
(Refer to the appropriate configuration tasks later in this chapter.)
Router(config)# Ctrl-Z
Command
Router# show running-config
Router# show startup-config
Router# copy running-config startup-config
Command
Router(config)# interface interface_type interface_num
Router(config-if)# no shutdown
Router(config-if)# Ctrl-Z
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
MSFC Command-Line Interface
2-11