Configuring A Dampening Interval - HP 7102dl - ProCurve Secure Router Configuration Manual

Network Monitoring
Configuring Network Monitoring
N o t e
9-28
To specify one probe, from the network monitor track configuration mode
context, enter:
Syntax: test probe <name>
Replace <name> with the probe's name, which is case sensitive.
To specify two probes, of which both must pass for the track to pass, enter:
Syntax: test probe <name> and probe <name>
To specify two probes, of which only one must pass for the track to pass, enter:
Syntax: test probe <name> or probe <name>
Table 9-4 shows the track's state based on statuses of its probes.
Table 9-4. Track and Probe States
Command Type Probe 1 Status
Single probe Pass
Fail
Or Pass
Pass
Fail
Fail
And Pass
Pass
Fail
Fail
If you want, you can associate the same probe with multiple tracks.

Configuring a Dampening Interval

Removing a route from the routing table is a relatively drastic action. If, in
addition to static routes, your ProCurve Secure Router also runs a routing
protocol and that protocol redistributes static routes, removing a route can
have repercussions throughout a network.
Probe 2 Status Track Status
Pass
Fail
Pass Pass
Fail Pass
Pass Pass
Fail Fail
Pass Pass
Fail Fail
Pass Fail
Fail Fail