Displaying Acps - HP 7102dl - ProCurve Secure Router Configuration Manual

Applying Access Control to Router Interfaces
Viewing ACLs and ACPs
5-52
As Figure 5-16 shows, this command lists the following information for
each ACL:
type of ACL—standard or extended
all entries in the ACLs
number of packets matched to each entry
ProCurve# show access-lists
Extended IP access list Internet
permit tcp any
permit tcp any
permit tcp any
permit tcp any
permit tcp any
permit tcp any
Extended IP access list WAN1
permit udp any
deny tcp any
permit tcp host 192.168.20.1
Figure 5-16. Displaying All the ACLs Configured on the Router
You can use this information to review the ACLs that are configured and to
ensure that they are configured correctly.

Displaying ACPs

To view all of the ACPs that are configured on the ProCurve Secure Router,
move to the enable mode context and enter:
Syntax: show ip policy-class
If you are in any other mode context (except the basic mode context), you
can enter:
Syntax: do show ip policy-class
As Figure 5-17 shows, entries for each ACP are displayed in order so you can
determine whether you need to reconfigure the policy. When an ACP is not
enforcing your policies in the way you expected, you may have entered
commands in the wrong order.
any eq www (300 matches)
any eq smtp (1 matches)
any eq pop3 (0 matches)
any eq ftp (0 matches)
any eq ftp-data (0 matches)
any eq domain (0 matches)
any eq rip (42 matches)
any eq telnet (0 matches)
any (0 matches)