Using the Web Browser Interface for Advanced Configuration Tasks
3.
Enable Stateless Processing, if applicable. Stateless Processing will allow
certain IP phones or POS stations to work in situations where stateful TcP
processing prevents these devices from working.
4.
Select a Destination Security Zone from the following choices:
•
Any
•
Self-bound
•
<other named zones>
The policy you are configuring will only be applied if the traffic is destined
for this specific security zone.
5.
Select a protocol from the following choices:
•
any
•
Specified
•
tcp
•
udp
•
icmp
•
gre
•
esp
•
ahp
If you select Specify, enter the number for the protocol in the field to
the right.
6.
For Source IP Address/Mask, select any or enter a specific IP address or
a specific subnet.
7.
Select a Destination IP Address/Mask. Again, you can select any or enter
a specific IP address or a specific subnet.
8.
If you have selected TCP or UDP for the protocol, you can specify a port
in the Filtered Ports section.
a.
You can select Any, choose a port from the list of well-known ports,
or enter a specific port.
Configuring Access Control from the Web Browser Interface
16-49