Submit Information To A Remote Web Server - HP 7102dl - ProCurve Secure Router Configuration Manual

ProCurve(config-probe-OptimalEmail)# timeout 500
ProCurve(config-probe-OptimalEmail)# tolerance rate-of-failure 4 10
ProCurve(config-probe-OptimalEmail)# no shutdown
ProCurve(config-probe-OptimalEmail)# exit
ProCurve(config)# probe MinimalEmail tcp-connect
ProCurve(config-probe-MinimalEmail)# destination www.mycompany.com port 25
ProCurve(config-probe-MinimalEmail)# timeout 2500
ProCurve(config-probe-MinimalEmail)# tolerance rate-of-failure 14 16
ProCurve(config-probe-MinimalEmail)# no shutdown
ProCurve(config-probe-MinimalEmail)# exit
2. Configure the tracks that monitor changes in performance.
ProCurve(config)# track OptimalWeb
ProCurve(config-track-OptimalWeb)# test probe OptimalWeb
ProCurve(config-track-OptimalWeb)# log-changes
ProCurve(config-track-OptimalWeb)# track MinimalWeb
ProCurve(config-track-MinimalWeb)# test probe MinimalWeb
ProCurve(config-track-MinimalWeb)# log-changes
ProCurve(config-track-MinimalWeb)# track OptimalEmail
ProCurve(config-track-OptimalEmail)# test probe OptimalEmail
ProCurve(config-track-OptimalEmail)# log-changes
ProCurve(config-track-OptimalEmail)# track MinimalEmail
ProCurve(config-track-MinimalEmail)# test probe MinimalEmail
ProCurve(config-track-MinimalEmail)# log-changes
ProCurve(config-track-MinimalEmail)# exit
3. Enable logs to be forwarded to a syslog server.
ProCurve(config)# logging forwarding on
ProCurve(config)# logging forwarding receiver-ip 10.12.1.43
ProCurve(config)# logging forwarding priority-level notice

Submit Information to a Remote Web Server

This scenario is similar to the first scenario. In this case, the local ProCurve
Secure Router monitors the connection to the Internet. If it cannot reach the
primary ISP (IP address 10.1.1.1) through an Ethernet connection to a cable
modem, a backup ISDN connection initiates. The router also periodically
notifies the headquarters Web server (IP address 10.5.4.20) which connection
is currently in use.
Network Monitoring
Configuring Network Monitoring
9-51