Configuring The Bri Or Modem Interface - HP 7102dl - ProCurve Secure Router Configuration Manual

Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
3-38
Replace <packets> with a number between 0 and 200. Replace <seconds>
with a number between 0 and 255.
By default, the ProCurve Secure Router holds 200 packets for 3 seconds. If
the number of packets received before the connection is established
exceeds 200 packets or if the connection is not established within 3 seconds,
the ProCurve Secure Router empties the hold queue. However, emptying the
hold queue does not terminate an activation attempt.

Configuring the BRI or Modem Interface

To configure the BRI interface, you need the following information from your
service provider:
ISDN signaling (switch) type
assigned telephone numbers (LDNs)
service profile IDs (SPIDs), if you are located in the United States or
Canada
You should have this information available before you begin configuring the
BRI interface. You must then complete the following steps:
1. Access the BRI interface configuration mode context.
2. Specify the ISDN switch type.
3. Assign the interface an LDN if you are using a BRI S/T interface, or assign
the BRI interface a SPID and LDN if you are using a BRI U interface
module.
4. Assign the BRI interface to the resource pool you created for the demand
interface.
5. Activate the BRI interface.
If you are configuring a modem interface, you:
1. Access the modem interface configuration mode context.
2. Specify the country code.
3. Assign the interface to the resource pool you created for the demand
interface.
4. Activate the modem interface.