Configure Acps; Action - HP 7102dl - ProCurve Secure Router Configuration Manual

To view a list of well-known ports, enter the
port commands (such as eq, gt, or neq). The list of options is displayed in
alphabetical order. You can either one of the keywords displayed or a specific
port number between 0 and 65535.
Specifying Bits in the Packets. To protect your network against attacks
and hackers scanning your network for information, you can block packets
based on certain bits set in the packet. You can specify the following bits:
ack
fin
psh
rst
syn
urg
Selecting the log Option. Include the log option if you want the Secure
Router OS to log a message when these two conditions are met:
debug access-list is enabled for this ACL
a packet matches this ACL
Enter the log-input option if you want the log to include the interface on
which packets that matched the entry were received.

Configure ACPs

You create entries in the ACP to specify how the Secure Router OS firewall
treats packets selected by ACLs. Each ACP entry contains two parts:
the action
the selector

Action

The action specifies exactly how the Secure Router OS firewall handles
packets selected by an ACL. ACPs can perform one of three actions on
selected packets:
allow the packets
discard the packets
manipulate the packets, using NAT to translate the source or destination
IP address to a different IP address
Applying Access Control to Router Interfaces
Using ACPs to Control Access to Router Interfaces
help command after one of the
?
5-35