Redistributing Connected And Static Routes - HP 7102dl - ProCurve Secure Router Configuration Manual

IP Routing—Configuring RIP, OSPF, BGP, and PBR
Configuring OSPF
However, if the external routes are limited, you can simply have the router
redistribute them into OSPF. For example, suppose that your router connects
to an external network that runs RIP. You can enable the router's WAN
interface to run RIP (see "Configuring RIP" on page 15-12) and then redistrib-
ute these routes into OSPF.
Move to the OSPF configuration mode context and enter:
ProCurve(config-ospf)# redistribute rip
If you do not want the redistributed routes to have the default cost of 20, add
a different metric. For example, to change the metric to 50, enter:
ProCurve(config-ospf)# redistribute rip metric 50
To limit the number of routes that the ASBR must advertise, you can configure
route summaries after redistributing the routes into OSPF. See "Configuring
Route Summaries for ASBRs" on page 15-55.

Redistributing Connected and Static Routes

All of a router's interfaces will not always run OSPF. An interface may connect
to a LAN that runs RIP or does not use dynamic routing. However, OSPF
interfaces do not transmit LSAs for a non-OSPF network. As far as peer routers
are concerned, a connection on a non-OSPF interface does not exist. If you
want OSPF to consider such connections when computing routes, you must
redistribute connected routes into OSPF.
From the OSPF configuration mode context, enter:
ProCurve(config-ospf)# redistribute connected
You can also redistribute static routes into OSPF. You can configure a metric
for redistributed connected or static routes just as you configure the metric
for RIP routes:
ProCurve(config-ospf)# redistribute static metric 30
N o t e
The redistribute connected command does not enable interfaces to send
or receive OSPF updates. You must use the network command to enable a
particular interface to send and receive OSPF updates.
15-59