HP 7102dl - ProCurve Secure Router Configuration Manual page 321

N o t e
Src IP Address
----------------
Policy class "Inside":
tcp (80)
192.168.20.1
Policy class "Outside":
tcp (20)
192.168.100.99
Policy class "self":
icmp (50)
0.0.0.0
The remaining options apply only to NAT:
Include the destination option to select a session that uses one-to-one
NAT (NAT based on the destination address). Include the source option
to select a session that uses many-to-one NAT (NAT based on the source
IP address).
Replace <nat A.B.C.D> with the IP address that replaced the original IP
address.
Replace <nat port> with the port used by NAT. Use hexadecimal format
for AHP, ESP, and GRE; use decimal format for all other protocols.
Rather than input this entire command, you can enter the show ip policy-
sessions command to display the current sessions and then copy the second
part of the command, beginning with the source IP address, from the display.
(See Figure 6-9.)
Src Port Dest IP Address
--------- --------------
2001 172.11.1.1
1908 172.16.3.10
10 192.168.100.1
Figure 6-9. Using the Information from the show ip policy-sessions Command to
Clear a Specific Session
Configuring Network Address Translation
Dst Port NAT IP Address
-------- ---------------
80 d 10.10.3.10
80 d 10.10.3.10
10
Highlight and copy
the entire line into
your command
Troubleshooting
NAT Port
-------
80
80
6-23