Show; Show Tech - HP 7102dl - ProCurve Secure Router Configuration Manual

Overview
CLI Tools
The CLI will prompt you to save the system configuration. If you have already
made the configurations that you want to test, reply no. If you are getting ready
to make the configurations to be tested and want to save previous configura-
tions, reply yes. The CLI then displays:
You are about to reboot the system. Continue? [y/n]
Enter . The system will not reboot immediately. It will wait the amount of time
y
you have specified. Remember that you must not save the running-config to
the startup-config (by entering either write mem or copy run start) while
you are configuring the router. Otherwise, the ProCurve Secure Router will
load these configurations when it reboots.
To cancel the reload, enter:
ProCurve# reload cancel

show

The show commands are only available in the enable mode context or by using
the do command. These commands allow you to check the router's configured
settings by displaying router functionality information in the CLI. This allows
you to find miskeyed commands or problem configurations and repair them.
Individual show commands are described throughout this book and the Basic
Management and Configuration Guide. For a more detailed list and expla-
nation of the available show commands, see the Basic Management and
Configuration Guide, Chapter 1: Overview.

show tech

Unlike the other show commands, the show tech command does not display
the information in the CLI. This command creates a file named showtech.txt
in internal flash that contains a summary of the router's show command
information.
To create this file enter show tech at the enable mode context prompt. This
will prepare a showtech.txt file and save it in the router's internal flash.
After the showtech.txt file is created, you can save it to compact flash or
upload it to a TFTP server. You can also save the contents of the showtech.txt
file to your terminal's text editor. See "Managing Configuration Files Using a
Text Editor" on page 1-25 for more information on how to manage files with
a text editor.
1-21