Mlfr Configuration - HP 7102dl - ProCurve Secure Router Configuration Manual

If you do not already have a PPP connection running, you must also:
5. Assign the PPP interface an IP address:
Syntax: ip address [<A.B.C.D> <subnet mask | /prefix length> | negotiated]
For example, you might enter:
ProCurve(config-ppp 1)# ip address 10.1.1.1 /30
You can also have the interface take its address from the far end of the
link (negotiated). A PPP interface can take a dynamic address from a
DHCP server only when it is acting as a bridge. The interface can also take
its address from another router interface, such as the Ethernet interface:
Syntax: ip unnumbered <interface ID>
6. Activate the PPP interface:
ProCurve(config-ppp 1)# no shutdown

MLFR Configuration

Before you begin completing these instruction, you should connect the phys-
ical interfaces to the appropriate public carrier equipment. You should also
have a non-multilink Frame Relay connection up and running.
1. Move to the global configuration mode context and configure the physical
interface(s) for the new carrier line(s):
a. Move to the interface configuration mode context:
Syntax: interface [e1 | t1] <slot>/<port>
b. Configure the TDM group. You can use the same TDM group as the
original line. You must use the same number of channels:
Syntax: tdm-group <tdm group number> timeslots <channels>
c. Activate the interface:
Syntax: no shutdown
d. Repeat these steps for each new carrier line.
2. Move to the Frame Relay interface for the connection:
Syntax: interface frame-relay <interface number>
3. Enable multilink functions:
ProCurve(config-fr 1)# frame-relay multilink
Increasing Bandwidth
Quick Start
2-21