Changing The Order Of Policies; Assigning The Security Zone (The Acp) To An Interface - HP 7102dl - ProCurve Secure Router Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks

Changing the Order of Policies

The policies you create for a security zone are listed and processed in the order
shown on the Configure Policies for Security Zone window. (Access this
window by clicking Security Zone <zonename> in the top navigation bar.) If
you need to change the order in which policies are processed, use the green
arrows to move a particular policy up or down in the list.
Figure 16-45. Changing the Order of Policies in a Security Zone

Assigning the Security Zone (the ACP) to an Interface

After you finish configuring the security zone (the ACP), you must assign it to
an interface. The security zone will have no effect until you complete this
final step.
1. In the navigation bar, select Security Zones under Firewall. The Assign
Interfaces to Security Zones window is displayed. The interfaces that are
enabled on the ProCurve Secure Router are listed in this window.
2. Use the pull-down menu to select a security zone for each interface, and
then click Assign.
3. If you need to edit the security zones you have created, you can access
them from this window.
Configuring Access Control from the Web Browser Interface
16-57