Configuring Frame Relay Fragmentation - HP 7102dl - ProCurve Secure Router Configuration Manual

Procurve secure router 7000dl series - advanced management and configuration guide
Hide thumbs Also See for 7102dl - ProCurve Secure Router:
Table of Contents

Advertisement

3.
Set the ToS value:
Syntax: set [dscp <0-63> | precedence <0-7>]
For example:
ProCurve(config-qos-map)# set dscp 34
4.
If so desired, configure another entry to mark other packets.
5.
Assign the QoS map to the logical interface that transmits the packets:
ProCurve(config)# interface ppp 1
ProCurve(config-ppp 1)# qos-policy out <mapname>

Configuring Frame Relay Fragmentation

1.
Enable rate limiting on a PVC:
a.
Move to the Frame Relay subinterface for the PVC:
ProCurve(config)# interface frame-relay <subinterface number>
Set the committed burst rate:
Syntax: frame-relay bc <bps>
For example:
ProCurve(config-fr 1.101)# frame-relay bc 700000
b. Set the excessive burst rate:
ProCurve(config-fr 1.101)# frame-relay be 400000
Syntax: frame-relay be <bps>
2.
Enable Frame Relay fragmentation for the PVC and set the fragment size:
Syntax: frame-relay fragment <bytes>
The threshold for fragmenting frames can be between 64 and 1600 bytes.
For example, enter:
ProCurve(config-fr 1.101)# frame-relay fragment 210
Setting Up Quality of Service
Quick Start
8-77

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve secure router 7203dl j8753a j8753a

Table of Contents