Configuring Peer Ip Address - HP 7102dl - ProCurve Secure Router Configuration Manual

data-call authentication protocol pap
data-call sent authentication protocol pap
!
interface bri 2/1
isdn ldn1 968483940096
resource pool-member Pool
no shutdown
!
interface bri 2/2
isdn ldn1 978484540055
resource pool-member Pool
no shutdown
!
interface demand 1
idle-timeout 240
resource pool Pool
match-interesting list Call out
match-interesting reverse list Call in
connect-sequence 1 dial-string 9633333 forced-isdn-64k busyout-threshold 3
connect-sequence 2 dial-string 9634444 forced-isdn-64k busyout-threshold 3
connect-sequence interface-recovery retry-interval 120 max-retries 0
ip address 10.1.1.1
ppp authentication pap
username procurve password procurve
ppp pap sent-username procurve password procurve
no shutdown
!
!ip access-list extended Call
permit ip any 192.168.2.0 0.0.0.255
255.255.255.0
Figure 3-12. Using PAP Authentication with Demand Routing

Configuring Peer IP Address

You can also configure the IP address of the PPP peer for the dial-up WAN
connection. From the demand interface configuration mode context, enter:
Syntax: peer default ip address <A.B.C.D>
Replace <A.B.C.D> with the IP address of the far-end router.
Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
data-call commands to
enable PAP authentication
PAP configured for this demand interface
username and password that the demand
interface expects to receive from its PPP peer
username and password that the demand
interface sends to its PPP peer
3-47