HP 7102dl - ProCurve Secure Router Configuration Manual page 189

Include the list option if you want the ProCurve Secure Router to use
standard matching logic for the ACL. Include the reverse list option
if you want the ProCurve Secure Router to use reverse matching logic
when processing the ACL. In this case, the router will try to match the
packet's source address with the destination address that is defined
in the ACL. The router will then try to match the packet's destination
address with the source address that is defined in the ACL.
Replace <listname> with the ACL that you created to define the
interesting traffic. You can specify only extended ACLs.
Including in or out is optional. By default, the ProCurve Secure
Router uses the ACL you specify to check both incoming and outgoing
traffic. If you do not specify a direction, outbound traffic is matched
to the specified ACL, and inbound traffic is matched to the reverse
of the ACL.
For example, if you want to apply the Backup ACL to demand 1
interface, enter:
ProCurve(config-demand 1)# match-interesting list Backup
d. Create a resource pool and associate it with the demand resource.
Enter:
ProCurve(config-demand 1)# resource pool <poolname>
Replace <poolname> with the name of the resource pool that this
demand routing interface will use to originate or answer connections.
e. Configure a connect sequence to specify:
– the telephone number that the demand interface dials to connect
to the other site
– the type of dial-up connection to establish
Enter the following command from the demand interface configura-
tion mode context:
Syntax: connect-sequence <sequence-number> dial-string <string>
[<resource-type>] [busyout-threshold <value>]
Replace <sequence-number> with a number between 1 and 65535
to identify this set of connection instructions.
Replace <string> with the LDN that the demand interface should dial
to make the connection.
Replace <resource-type> with one of the options listed in Table 3-
20. The option you enter will limit this connection to a particular type
of dial-up connection.
Configuring Backup WAN Connections
Quick Start
3-101