Basic Commands; Exit - HP 7102dl - ProCurve Secure Router Configuration Manual

Overview
CLI Tools
be checked by pressing after typing en at the basic mode context prompt.
Tab
Because the Secure Router OS is able to finish the word enable, it completes
the truncated command.

Basic Commands

This section gives some basic CLI commands that you will need to operate
your router. Only basic commands are described here. For a more compre-
hensive list and description of router commands, see the Basic Management
and Configuration Guide, Chapter 1: Overview; or the SROS Command Line
Interface Reference Guide.
no
In the enable security mode context, typing the word no before a command
turns off or resets a command option to its defaults. For example, if you want
to stop events notices from displaying to the CLI screen, enter no events.
do
When in the configuration mode context, if you need to execute an enable
mode command, type do before you enter the command. The do command
allows you to stay in your current mode context while executing a command
that is usually only available in the enable mode context. You will most often
use this command with show commands. For example, to display the status
of an interface while configuring a protocol interface, enter:
Syntax: do show interface <interface type> <slot>/<port>
ProCurve(config-ppp 1)# do show interface e1 1/1

exit

To leave a specific interface or configuration mode, type exit. The exit
command moves you back one mode level. For example, if you were config-
uring an ATM interface in the ATM interface configuration mode context and
entered exit when you were finished, you would return to the global config-
uration mode context.
When you enter the exit command in the global configuration mode context
and return to the enable mode context, the CLI displays this message:
Appropriate commands must be issued to preserve configuration.
1-15