Quick Start - HP 7102dl - ProCurve Secure Router Configuration Manual

Quick Start

This section provides the commands you must enter to quickly configure Web
content filtering.
Only a minimal explanation is provided. If you need additional information
about any of these options, see "Contents" on page 7-1 to locate the section
and page number that contains the explanation you need.
Before performing these steps, you should have already deployed a Websense
solution and configured all necessary filtering policies on that solution.
1. On the ProCurve Secure Router, move to the global configuration mode
context and enable the firewall.
Syntax: ip firewall
2. Create a named filter.
Syntax: ip urlfilter <name> http
3. Specify your Websense server's IP address. The default port for the server
is 15868, and its timeout is 5 seconds. Optionally, you can change those
settings.
Syntax: ip urlfilter server <A.B.C.D> [port <1 to 65535>] [timeout <1 to 300
seconds>]
You can enter the command multiple times if your WAN includes more
than one Websense server.
4. Decide how you want the router to behave should the Websense server
become unreachable. By default, the router drops all external HTTP
traffic. To have the router allow all such traffic, enter this command:
Syntax: ip urlfilter allowmode
Content Filtering
Quick Start
7-21