Enabling Dhcp; Enabling The Dhcp Server On An Interface; Applying An Address Pool On An Interface - HP FlexNetwork MSR2003 Configuration Manual

Step
2. Create a DHCP user class
and enter DHCP user class
view.
3. Configure a match rule for
the DHCP user class.
4. Return to system view.
5. Create a DHCP address pool
and enter DHCP address
pool view.
6. Enable the DHCP user class
whitelist.
7. Add DHCP user classes to
the DHCP user class
whitelist.

Enabling DHCP

You must enable DHCP to validate other DHCP configurations.
To enable DHCP:
Step
1. Enter system view.
2. Enable DHCP.

Enabling the DHCP server on an interface

Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns the client an IP address and other configuration parameters from
a DHCP address pool.
To enable the DHCP server on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Enable the DHCP server on
the interface.

Applying an address pool on an interface

Perform this task to apply a DHCP address pool on an interface.
Command
dhcp class class-name
if-match rule rule-number
{ option option-code [ hex
hex-string [ mask mask | offset
offset length length ] ] |
hardware-address
hardware-address mask
hardware-address-mask }
quit
dhcp server ip-pool pool-name
verify class
valid class class-name&<1-8>
Command
system-view
dhcp enable
Command
system-view
interface interface-type
interface-number
dhcp select server
49
Remarks
By default, no DHCP user class
exists.
By default, no match rule is
configured for a DHCP user class.
N/A
By default, no DHCP address pool
exists.
By default, the DHCP user class
whitelist is disabled.
By default, no DHCP user class is
on the DHCP user class whitelist.
Remarks
N/A
By default, DHCP is disabled.
Remarks
N/A
N/A
By default, the DHCP server on
the interface is enabled.