HP 7102dl - ProCurve Secure Router Configuration Manual page 931

Using the Web Browser Interface for Advanced Configuration Tasks
Managing AutoSynch™, Files, Firmware, Logging, and Boot Software
7. When you have selected all of the debug filters that you want, click the
Start Debug button. Messages generated for the selected debug filters will
then be displayed on the screen.
Figure 16-16. View/Manage Debug Output
For a full explanation of the output for each debug filter in the Web
interface, see the corresponding CLI debug command in the troubleshoot-
ing section of the applicable chapter in this manual or the Advanced
Management and Configuration Guide.
8. You can click the following buttons on the screen while debug is running:
• Pause Debug and Restart Debug—to pause and then restart the debug
output on the screen. While the output is paused, you can examine
the existing debug messages, but no new messages will be generated
until you restart the output.
• Stop Debug—to stop the debug output. If you want, you can then add
or delete debug filters and start the debug output again (see steps 2
through 7).
16-17