Using the Web Browser Interface for Advanced Configuration Tasks
Configuring Access Control from the Web Browser Interface
16-48
7.
Click Apply. The policy you created is now listed on the Configure
Policies for Security Zone window.
Allowing Traffic
1.
To allow certain traffic to enter an interface, use the pull-down menu to
select Allow for the Policy Type in the Add New Policy window. Click
Continue. The Add New Policy to Security Zone window is displayed.
Figure 16-39. Permitting Traffic to Enter an Interface
2.
Enter a policy descriptor, which will be displayed when you view the
running-config. For example, you may want to use the policy descriptor
to document how the ACP is going to be used. You could enter:
Control access to Eth 0/1 interface