Removing A Hot Plug Board - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 6
To access the PCI Hot Plug Replacement procedures for the respective NOS, you
must have the HP NetServer Navigator CD-ROM provided with the HP NetServer
LH 6000.
To view the respective Hot Plug Replacement (NOS) procedures:
1. Insert the HP NetServer Navigator CD-ROM into a CD drive.
2. Select NetServers LH-Series button.
3. Scroll down to and select NetServer LH 6000 in the list.
4. Select Install.
5. Select Installing Accessory Boards.
6. Select the appropriate Hot Plug Replacement topic.
NOTE
To perform a hot add, or a hot replacement when the HP
NetServer is powered up, refer to the PCI Hot Plug Help file on
the HP NetServer Navigator CD-ROM.

Removing a Hot Plug Board

To remove a hot-plug board from the HP NetServer which has not been powered
up:
1. Make sure power is off and follow the instructions for accessing the I/O
board.
2. Open the PCI hold-down latch.
3. Pull the gray plastic slot ejector (see Figure 6-6) out until you feel
resistance (about three-eighths of an inch, or 10mm).
This releases the hot-plug board from the I/O board connector.
68
Installing Additional Boards