Installing Additional Boards; Introduction - HP LC2000r - NetServer - 128 MB RAM Installation Manual

6 Installing Additional Boards

Introduction

This chapter describes how to install accessory boards into the I/O board. The I/O
board is located under the top cover of the LH 6000r and under the left cover of
the LH 6000. Refer to Chapter 3, "Opening and Closing the HP NetServer," for
instructions on removing the covers.
Remote
Management
Slots 1- 4
Non-
Slots 1- 6
hot-plug
+5V
33 MHz/64 Bit
Slots 5- 8
Hot-plug
Slots 7
and 8
+3.3V or +5V
66 MHz/64 Bit
Power LEDs
The I/O board provides eight slots. All eight slots support standard PCI boards and
slots 5, 6, 7, and 8 support PCI boards with the Hot Plug option.
The I/O board comprises:
Eight PCI Board slots
l
The PCI Hot-Plug LEDs
The two Ultra-2 SCSI connectors, A and B
I/O Memory
Attention LEDs
Figure 6-1. I/O Board
SE SCSI
SCSI A
SCSI B
59