Equipment For Installing The Ics And Modules; Location Requirements - Nortel ICS Install Manual

200 / Planning the installation

Equipment for installing the ICS and modules

screwdriver
å
å pliers
å connecting tool (punch-down tool)
å four 19 mm (3/4 in.) wood screws for each of the mounting
brackets
å 38 mm (1 1/2 in.) screws for the cable troughs (two screws
for the ICS and SM, four screws for the TM)
19 mm (3/4 in.) thick wooden backboard
å

Location requirements

minimum distance of 4 m (13 ft.) from equipment such as
å
photocopiers, electrical motors, and other equipment that
can produce electromagnetic, radio-frequency (RF), or
electrostatic interference
clean, dry, and well-ventilated
å
å minimum clearance of 150 mm (5 in.) above and 100 mm
(4 in.) below the ICS
å the gap between the ICS and the wall should be left
completely clear to allow proper heat dissipation
å temperature between 0°C and 50°C (32°F and 122°F)
humidity between 5% and 95%, non-condensing
å
Modular ICS 7.1 Installer Guide N0130943 02