Controlling Management Access (CLI)
This section provides information about the commands you use to control
access to the switch management interface. For more information about
these commands, see the
Reference Guide
Configuring a Management Access List
NOTE:
Management ACLs can be applied only to in-band ports and cannot be
applied to the OOB port.
Beginning in Privileged EXEC mode, use the following commands to create a
management access list. There is an implicit deny-all rule at the end of every
management ACL. This means that any host that does not meet the criteria
defined in a permit command is denied access to the management interface.
Command
configure
management access-list
name
216
Controlling Management Access
PowerConnect M6220/M6348/M8024/M8024-k CLI
at support.dell.com/manuals.
Purpose
Enter Global Configuration mode.
Define an access list for management, and enter the
access-list for configuration.