Configuring Dead Time Intervals; About Retransmitting Intervals; Configuring Retransmitting Intervals - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Fibre Channel Routing Services and Protocols
This value must be the same in the ports at both ends of the ISL.
Note
Caution An error is reported at the command prompt if the configured dead time interval is less than the hello time
interval.

Configuring Dead Time Intervals

To configure the FSPF dead time interval, perform this task:
Procedure
Step 1
Step 2
Step 3

About Retransmitting Intervals

You can specify the time after which an unacknowledged link state update should be transmitted on the
interface. The integer value to specify retransmit intervals can range from 1 to 65,535 seconds.
This value must be the same on the switches on both ends of the interface.
Note

Configuring Retransmitting Intervals

To configure the FSPF retransmit time interval, perform this task:
Procedure
Step 1
Step 2
OL-16597-01
Command or Action
switch# configuration terminal
switch(config)# interface fc slot/port
switch(config-if)# fspf dead-interval
value vsan vsan-id
Command or Action
switch# configuration terminal
switch(config)# interface fc slot/port
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring Dead Time Intervals
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the specified
interface.
Specifies the maximum interval for the specified VSAN
before which a hello message must be received on the
selected interface before the neighbor is considered lost.
The default is 80 seconds.
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the specified
interface.
583