About Dead Time Intervals; Configuring Dead Time Intervals; About Retransmitting Intervals - Cisco nexus 5000 series Cli Configuration Manual
Hide thumbs
Also See for nexus 5000 series:
- Configuration manual (334 pages) ,
- Command reference manual (196 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
Chapter 1
Configuring Fibre Channel Routing Services and Protocols
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Command
Step 2
switch(config)# interface fc slot/port
switch(config-if)#
Step 3
switch(config-if)# fspf hello-interval value vsan
vsan-id
switch(config-if)#
About Dead Time Intervals
You can set the FSPF dead time interval to specify the maximum interval for which a hello message must
be received before the neighbor is considered lost and removed from the database. The integer value can
range from 1 to 65,535 seconds.
This value must be the same in the ports at both ends of the ISL.
Note
Caution
An error is reported at the command prompt if the configured dead time interval is less than the hello
time interval.
Configuring Dead Time Intervals
To configure the FSPF dead time interval, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# interface fc slot/port
switch(config-if)#
Step 3
switch(config-if)# fspf dead-interval
value vsan vsan-id
switch(config-if)#
About Retransmitting Intervals
You can specify the time after which an unacknowledged link state update should be transmitted on the
interface. The integer value to specify retransmit intervals can range from 1 to 65,535 seconds.
This value must be the same on the switches on both ends of the interface.
Note
OL-16597-01
Purpose
Configures the specified interface, or if
already configured, enters configuration
mode for the specified interface.
Specifies the hello message interval to
verify the health of the link in VSAN 175.
The default is 20 seconds.
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the maximum interval for the specified
VSAN before which a hello message must be
received on the selected interface before the
neighbor is considered lost. The default is 80
seconds.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
FSPF Interface Configuration
1-7
Advertisement
Chapters
Table of Contents
Troubleshooting
