Configuring Fspf On A Vsan; Resetting Fspf To The Default Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring FSPF on a VSAN

Table 83: LSR Default Settings
LSR Option
Acknowledgment interval
(RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
The LSR minimum arrival time is the period between receiving LSR updates on this VSAN. Any LSR updates
that arrive before the LSR minimum arrival time are discarded.
The LSR minimum interval time is the frequency at which this switch sends LSR updates on a VSAN.
Configuring FSPF on a VSAN
To configure an FSPF feature for the entire VSAN, perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5

Resetting FSPF to the Default Configuration

To return the FSPF VSAN global configuration to its factory default, perform this task:
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
580
Default
5 seconds
30 minutes
60 minutes
Command or Action
switch# configuration terminal
switch(config)# fspf config vsan
vsan-id
switch-config-(fspf-config)# spf
static
switch-config-(fspf-config)# spf
hold-time value
switch-config-(fspf-config)# region
region-id
Configuring Fibre Channel Routing Services and Protocols
Description
The time a switch waits for an
acknowledgment from the LSR
before retransmission.
The time a switch waits before
sending an LSR refresh
transmission.
The time a switch waits before
dropping the LSR from the
database.
Purpose
Enters configuration mode.
Enters FSPF global configuration mode for the specified
VSAN.
Forces static SPF computation for the dynamic (default)
incremental VSAN.
Configures the hold time between two route
computations in milliseconds (msec) for the entire
VSAN. The default value is 0.
If the specified time is shorter, the routing is
Note
faster. However, the processor consumption
increases accordingly.
Configures the autonomous region for this VSAN and
specifies the region ID.
OL-16597-01