Mapping Vsans To Vlans Example Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Associating a Virtual Fibre Channel Interface to a VSAN
This example shows how to display the status of all the interfaces on the switch (some output has been removed
for brevity):
switch# show interface brief
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
fc3/1
fc3/2
...
fc3/8
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
Ethernet1/1
Ethernet1/2
Ethernet1/3
...
Ethernet1/39
Ethernet1/40
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
mgmt0
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
vfc 1
...
This example shows how to display the mapping between the VLANs and VSANs on the switch:
switch# show vlan fcoe
VLAN
--------
15
20
25
30

Mapping VSANs to VLANs Example Configuration

The following example shows how to configure the FCoE VLAN and a virtual Fibre Channel interface:
Procedure
Step 1 Configure the VLAN on a physical Ethernet address.
switch# configure terminal
switch(config)# interface ethernet 1/4
switch(config-if)# spanning-tree port type edge trunk
switch(config-if)# switchport mode trunk
switch(config-if)# switchport trunk allowed vlan 1,200
switch(config-if)# exit
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
416
Vsan Admin Admin Status
Mode Trunk
Mode
1 auto on trunking
1 auto on sfpAbsent
1 auto on sfpAbsent
Status
hwFailure
hwFailure
up
sfpIsAbsen --
sfpIsAbsen --
Status
up
Vsan Admin Admin Status
Mode Trunk
Mode
1 F --
VSAN Status
-------- --------
15 Operational
20 Operational
25 Operational
30 Non-operational
Mapping VSANs to VLANs Example Configuration
SFP Oper
Mode
swl TE
-- --
-- --
IP Address Speed
-- --
-- --
-- 10000
--
--
IP Address Speed
172.16.24.41 100
SFP Oper
Mode
down --
Oper Port
Speed Channel
(Gbps)
2 --
--
--
MTU Port
Channel
1500 --
1500 --
1500 --
1500 --
1500 --
MTU
1500
Oper Port
Speed Channel
(Gbps)
-- --
OL-16597-01