Syslog Servers; Configuring System Message Logging; Configuring System Message Logging To Terminal Sessions - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

syslog Servers

Level
5 – notification
6 – informational
7 – debugging
The switch logs the most recent 100 messages of severity 0, 1, or 2 to the NVRAM log. You cannot configure
logging to the NVRAM.
You can configure which system messages should be logged based on the facility that generated the message
and its severity level.
Related Topics
syslog Servers
syslog servers run on remote systems that are configured to log system messages based on the syslog protocol.
You can configure the Cisco Nexus 5000 Series to sends its logs to up to three syslog servers.
To support the same configuration of syslog servers on all switches in a fabric, you can use the Cisco Fabric
Services (CFS) to distribute the syslog server configuration.
When the switch first initializes, messages are sent to syslog servers only after the network is initialized.
Note

Configuring System Message Logging

Configuring System Message Logging to Terminal Sessions

You can configure the switch to log messages by their severity level to console, Telnet, and SSH sessions.
By default, logging is enabled for terminal sessions.
Procedure
Step 1
Step 2
Step 3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
336
Configuring Module and Facility Messages Logging, page 339
Configuring System Message Logging to a File, page 338
Configuring System Message Logging to Terminal Sessions, page 336
Command or Action
switch# terminal monitor
switch# configure terminal
switch(config)# logging console
[severity-level]
Configuring System Message Logging
Description
Normal but significant condition
Informational message only
Appears during debugging only
Purpose
Copies syslog messages from the console to the current
terminal session.
Enters configuration mode.
Enables the switch to log messages to the console session
based on a specified severity level or higher (a lower number
OL-16597-01

Advertisement

Table of Contents
loading

Table of Contents