Disabling Fcoe - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Disabling FCoE

All the Fibre Channel features of the Cisco Nexus 5000 Series switch are packaged in the FC Plugin.
Note
When you enable FCoE, the switch software checks for the FC_FEATURES_PKG license. If it finds the
license, the software loads the plugin. If the license is not found, the software loads the plugin with a grace
period of 180 days.
After the FC Plugin is loaded, the following occurs:
• All Fibre Channel and FCoE related CLI are available
• The Fibre Channel interfaces of any installed Expansion Modules are available
If after 180 days, a valid license is not found, the FC Plugin is disabled. At the next switch reboot, all
FCoE commands are removed from the CLI and the FCoE configuration is deleted.
Before You Begin
You need to have the FC_FEATURES_PKG (N5010SS or N5020SS) license installed.
Procedure
Step 1
Step 2
This example shows how to enable FCoE on the switch:
switch# configure terminal
switch(config)# feature fcoe
Disabling FCoE
After you disable FCoE, all FCoE commands are removed from the CLI and the FCoE configuration is deleted
.
Procedure
Step 1
Step 2
This example shows how to disable FCoE on the switch:
switch# configure terminal
switch(config)# no feature fcoe
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
404
Command or Action
switch# configure terminal
switch(config)# feature fcoe
Command or Action
switch# configure terminal
switch(config)# no feature fcoe
Configuring FCoE
Purpose
Enters configuration mode.
Enables the FCoE capability.
Purpose
Enters configuration mode.
Disables the FCoE capability.
OL-16597-01