Configuring Time Intervals For Advertisement Packets - Cisco Nexus 3000 Series Configuration Manual

Configuring VRRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
interface interface-type slot/port
Example:
switch(config)# interface ethernet 2/1
switch(config-if)#
Step 3
no switchport
Example:
switch(config-if)# no switchport
Step 4
vrrp number
Example:
switch(config-if)# vrrp 250
switch(config-if-vrrp)#
Step 5
shutdown
Example:
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)#
Step 6
authentication text password
Example:
switch(config-if-vrrp)# authentication md5
prd555oln47espn0 spi 0x0
Step 7
no shutdown
Example:
switch(config-if-vrrp)# no shutdown
switch(config-if-vrrp)#
Step 8
show vrrp
Example:
switch(config-if-vrrp)# show vrrp
Step 9
copy running-config startup-config
Example:
switch(config-if-vrrp)# copy
running-config startup-config

Configuring Time Intervals for Advertisement Packets

You can configure the time intervals for advertisement packets.
BEFORE YOU BEGIN
Ensure that you have enabled the VRRP feature (see the
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
13-12
Chapter 13
Purpose
Enters configuration mode.
Enters interface configuration mode.
Configures the interface as a Layer 3 routed
interface.
Creates a virtual router group.
Disables the VRRP group. Disabled by default.
Assigns the simple text authentication option and
specifies the keyname password. The keyname
range is from 1 to 255 characters. We recommend
that you use at least 16 characters. The text
password is up to eight alphanumeric characters.
Enables the VRRP group. Disabled by default.
(Optional) Displays a summary of VRRP
information.
(Optional) Saves this configuration change.
"Configuring VRRP" section on page
Configuring VRRP
13-7).