Applying A Mac Acl As A Port Acl; Verifying Mac Acl Configurations - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Applying a MAC ACL as a Port ACL

Step 4
Related Topics
•
Applying a MAC ACL as a Port ACL
You can apply a MAC ACL as a port ACL to any of the following interface types:
• Ethernet interfaces
• EtherChannel interfaces
Be sure that the ACL that you want to apply exists and is configured to filter traffic as necessary for this
application.
Note Some configuration parameters when applied to an EtherChannel are not reflected on the configuration
of the member ports.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Related Topics
•

Verifying MAC ACL Configurations

To display MAC ACL configuration information, perform one of the following tasks:
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
290
Command or Action
switch# copy running-config
startup-config
Rules, page 280
Command or Action
switch# configure terminal
switch(config)# interface {ethernet
[chassis/]slot/port | port-channel
channel-number}
switch(config-if)# mac port access-group
access-list
switch# show running-config
switch# copy running-config startup-config
Creating an IP ACL, page 283
Purpose
(Optional)
Copies the running configuration to the startup
configuration.
Purpose
Enters configuration mode.
Enters interface configuration mode for the
Ethernet specified interface.
Applies a MAC ACL to the interface.
(Optional)
Displays ACL configuration.
(Optional)
Copies the running configuration to the startup
configuration.
Configuring MAC ACLs
OL-16597-01