Adding Show Commands To An Alert Group - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Adding show Commands to an Alert Group

Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
This example shows how to associate all alert groups with the destination profile Noc101:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# destination-profile Noc101 alert-group All
Adding show Commands to an Alert Group
You can assign a maximum of five user-defined CLI show commands to an alert group.
Procedure
Step 1
Step 2
Step 3
Step 4
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
358
Command or Action
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# destination-profile
name alert-group {All | Cisco-TAC |
Configuration | Diagnostic | Environmental |
Inventory | License | Linecard-Hardware |
Supervisor-Hardware | Syslog-group-port |
System | Test}
switch# show callhome destination-profile
[profile name]
switch# copy running-config startup-config
Command or Action
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# alert-group
{Configuration | Diagnostic |
Environmental | Inventory | License |
Linecard-Hardware |
Supervisor-Hardware | Syslog-group-port
| System | Test} user-def-cmd show-cmd
switch# show callhome user-def-cmds
Configuring Smart Call Home
Purpose
Enters configuration mode.
Enters callhome configuration mode.
Associates an alert group with this
destination profile. Use the All keyword to
associate all alert groups with the destination
profile.
(Optional)
Displays information about one or more
destination profiles.
(Optional)
Saves this configuration change.
Purpose
Enters configuration mode.
Enters callhome configuration mode.
Adds the show command output to any Call Home
messages sent for this alert group. You must
enclose the show command in double quotes. Only
valid show commands are accepted.
You cannot add user-defined CLI show
Note
commands to the CiscoTAC-1 destination
profile.
(Optional)
Displays information about all user-defined show
commands added to alert groups.
OL-16597-01