Configuring The Lacp System Priority And System Id; Configuring The Lacp Port Priority - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring EtherChannels
Step 4
This example shows how to set the LACP-enabled interface to active port-channel mode for Ethernet interface
1/4 in channel group 5:
switch# configure terminal
switch (config)# interface ethernet 1/4
switch(config-if)# channel-group 5 mode active

Configuring the LACP System Priority and System ID

The LACP system ID is the combination of the LACP system priority value and the MAC address.
Before You Begin
Ensure that you have enabled the LACP feature.
Procedure
Step 1
Step 2
Step 3
This example shows how to set the LACP system priority to 2500:
switch# configure terminal
switch(config)# lacp system-priority 2500

Configuring the LACP Port Priority

You can configure each link in the LACP EtherChannel for the port priority.
Before You Begin
Ensure that you have enabled the LACP feature.
Procedure
Step 1
OL-16597-01
Command or Action
switch(config-if)# no channel-group
number mode
Command or Action
switch# configure terminal
switch(config)# lacp system-priority
priority
switch# show lacp system-identifier
Command or Action
switch# configure terminal
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring the LACP System Priority and System ID
Purpose
Returns the port mode to on for the specified interface.
Purpose
Enters configuration mode.
Configures the system priority for use with LACP.
Valid values are 1 through 65535, and higher numbers
have lower priority. The default value is 32768.
(Optional)
Displays the LACP system identifier.
Purpose
Enters configuration mode.
121