Verifying Interoperating Status - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Verifying Interoperating Status

Note
switch(config)# fctimer e_d_tov ?
<1000-100000> E_D_TOV in milliseconds(1000-100000)
switch(config)# fctimer r_a_tov ?
<5000-100000> R_A_TOV in milliseconds(5000-100000)
Step 4 When making changes to the domain, you may or may not need to restart the domain manager function for
the altered VSAN.
• Force a fabric reconfiguration with the disruptive option.
or
• Do not force a fabric reconfiguration.
Verifying Interoperating Status
This section highlights the commands used to verify if the fabric is up and running in interoperability mode.
To verify the resulting status of entering the interoperability command in any switch in the Cisco Nexus 5000
Series, perform this task:
Procedure
Step 1 Verify the software version.
Example:
switch# show version
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2008, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
618
The Cisco Nexus 5000 Series, Brocade, and McData FC Error Detect (ED_TOV) and Resource
Allocation (RA_TOV) timers default to the same values. They can be changed if needed. The RA_TOV
default is 10 seconds, and the ED_TOV default is 2 seconds. Per the FC-SW2 standard, these values
must be the same on each switch within the fabric.
switch(config)# fcdomain restart disruptive vsan 1
switch(config# fcdomain restart vsan 1
Advanced Fibre Channel Features and Concepts
OL-16597-01