Sample Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring FC-SP and DHCHAP

Sample Configuration

This section provides the steps to configure the example illustrated in the following figure.
Figure 75: Sample DHCHAP Authentication
To configure the authentication setup shown in the above figure, perform this task:
Procedure
Step 1 Obtain the device name of the Cisco Nexus 5000 Series switch in the fabric. The Cisco Nexus 5000 Series
switch in the fabric is identified by the switch WWN.
Example:
switch# show wwn switch
Switch WWN is 20:00:00:05:30:00:54:de
Step 2 Explicitly enable DHCHAP in this switch.
Note
Example:
switch(config)# fcsp enable
Step 3 Configure a clear text password for this switch. This password will be used by the connecting device.
Example:
switch(config)# fcsp dhchap password rtp9216
Step 4 Configure a password for another switch in the fabric that is identified by the switch WWN device name.
Example:
switch(config)# fcsp dhchap devicename 20:00:00:05:30:00:38:5e password rtp9509
Step 5 Enable the DHCHAP mode for the required Fibre Channel interface.
Note
Example:
switch(config)# interface fc2/4
switch(config-if)# fcsp on
Step 6 Verify the protocol security information configured in this switch by displaying the DHCHAP local password
database.
OL-16597-01
When you disable DHCHAP, all related configurations are automatically discarded.
Whenever DHCHAP port mode is changed to a mode other than the Off mode, reauthentication is
performed.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Sample Configuration
633