Configuring System Message Logging; Information About System Message Logging - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Configuring System Message Logging

This chapter describes how to configure system message logging on the Cisco Nexus 5000 Series switch

and contains the following sections:

You can use system message logging to control the destination and to filter the severity level of messages that

system processes generate. You can configure logging to terminal sessions, a log file, and syslog servers on

remote systems.

By default, the Cisco Nexus 5000 Series switch outputs messages to terminal sessions.

By default, the switch logs system messages to a log file.

The following table describes the severity levels used in system messages. When you configure the severity

level, the system outputs messages at that level and lower.

Table 40: System Message Severity Levels

0 – emergency

2 – critical

Information About System Message Logging, page 335

Configuring System Message Logging, page 336

Verifying System Message Logging Configuration, page 345

Default System Message Logging Settings, page 346

C H A P T E R

System unusable

Immediate action needed

Critical condition

Error condition

Warning condition

Cisco Nexus 5000 Series Switch CLI Software Configuration Guide

Table of Contents

Do you have a question about the AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?