Configuring System Message Logging
Configuring syslog on a UNIX or Linux System
You can configure a syslog server on a UNIX or Linux system by adding the following line to the
/etc/syslog.conf file:
facility.level <five tab characters> action
The following table describes the syslog fields that you can configure.
Table 41: syslog Fields in syslog.conf
Field
Facility
Level
Action
Procedure
Step 1
Log debug messages with the local7 facility in the file /var/log/myfile.log by adding the following line to the
/etc/syslog.conf file:
debug.local7
Step 2
Create the log file by entering these commands at the shell prompt:
$ touch /var/log/myfile.log
$ chmod 666 /var/log/myfile.log
Step 3
Make sure the system message logging daemon reads the new changes by checking myfile.log after entering
this command:
$ kill -HUP ~cat /etc/syslog.pid~
Configuring syslog Server Configuration Distribution
You can distribute the syslog server configuration to other switches in the network by using the Cisco Fabric
Services (CFS) infrastructure.
OL-16597-01
Description
Creator of the message, which can be auth, authpriv,
cron, daemon, kern, lpr, mail, mark, news, syslog,
user, local0 through local7, or an asterisk (*) for all.
These facility designators allow you to control the
destination of messages based on their origin.
Note
Minimum severity level at which messages are
logged, which can be debug, info, notice, warning,
err, crit, alert, emerg, or an asterisk (*) for all. You
can use none to disable a facility.
Destination for messages, which can be a filename,
a host name preceded by the at sign (@), or a
comma-separated list of users or an asterisk (*) for
all logged-in users.
/var/log/myfile.log
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring syslog on a UNIX or Linux System
Check your configuration before using a
local facility.
343
Need help?
Do you have a question about the AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?
Questions and answers