Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 461

Verifying the Virtual Interface
Command
switch# show interface vfc vfc-id
switch# show interface brief
switch# show vlan fcoe
This example shows how to display a virtual Fibre Channel interface bound to an Ethernet interface:
switch# show interface vfc 3
vfc3 is up
Bound interface is Ethernet1/37
Hardware is Virtual Fibre Channel
Port WWN is 20:02:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is F, FCID is 0x490100
Port vsan is 931
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
Interface last changed at Thu May 21 04:44:42 2009
This example shows how to display a virtual Fibre Channel interface bound to a MAC address:
switch# show interface vfc 1001
vfc1001 is down
Bound MAC is 00:0a:00:00:00:01
Hardware is Virtual Fibre Channel
Port WWN is 23:e8:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 901
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
OL-16597-01
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
Associating a Virtual Fibre Channel Interface to a VSAN
Purpose
Displays the detailed configuration of the specified
Fibre Channel interface.
Displays the status of all interfaces.
Displays the mapping of FCoE VLANs to VSANs.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
415