Default Physical Ethernet Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Displaying Interface Information

Default Physical Ethernet Settings

The following table lists the default settings for all physical Ethernet interfaces:

Encapsulation

2 MTU cannot be changed per-physical Ethernet interface. You modify MTU by selecting maps of QoS classes.

Default Setting

Enable, 100 milliseconds

Auto (full-duplex)

Auto (10000)

Cisco Nexus 5000 Series Switch CLI Software Configuration Guide

Default Physical Ethernet Settings

Table of Contents

Do you have a question about the AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?