Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 85

Configuring the Switch
Example:
Configure NTP server? (yes/no) [n]: yes
NTP server IP address: ntp_server_IP_address
Step 13 Enter yes (yes is the default) to configure basic Fibre Channel configurations.
Example:
Enter basic FC configurations (yes/no) [n]: yes
Step 14 Enter shut (shut is the default) to configure the default Fibre Channel switch port interface to the shut (disabled)
state.
Example:
Configure default physical FC switchport interface state (shut/noshut) [shut]: shut
Step 15 Enter on (on is the default) to configure the switch port trunk mode.
Example:
Configure default physical FC switchport trunk mode (on/off/auto) [on]: on
Step 16 Enter permit (deny is the default) to deny a default zone policy configuration.
Example:
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Note
Step 17 Enter yes (no is the default) to enable a full zone set distribution.
Example:
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
Step 18 You see the new configuration. Review and edit the configuration that you have just entered. Enter no (no is
the default) if you are satisfied with the configuration.
Example:
The following configuration will be applied:
username admin password <user-password> role network-admin
snmp-server community snmp_community ro
switchname switch
feature telnet
ssh key dsa 768 force
feature ssh
system default switchport shutdown san
system default switchport trunk mode on
system default zone default-zone permit
system default zone distribute full
Would you like to edit the configuration? (yes/no) [n]: no
OL-16597-01
If you are executing the setup script after entering a write erase command, you explicitly must change
the default zone policy to permit for VSAN 1 after finishing the script using the following command:
Configure read-only SNMP community string (yes/no) [n]: zone default-zone permit
vsan 1
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring the Switch
39