Default System Message Logging Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Displaying and Clearing Log Files
Command
switch# show logging level [facility]
switch# show logging logfile [start-time yyyy mmm
dd hh:mm:ss] [end-time yyyy mmm dd hh:mm:ss]
switch# show logging module
switch# show logging monitor
switch# show logging nvram [last number-lines]
switch# show logging pending
switch# show logging pending-diff
switch# show logging server
switch# show logging session
switch# show logging status
switch# show logging timestamp

Default System Message Logging Settings

The following table lists the default settings for system message logging parameters.
Table 42: Default System Message Logging Parameters
Parameters
Console logging
Monitor logging
Log file logging
Module logging
Facility logging
Time-stamp units
syslog server logging
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
346
Default System Message Logging Settings
Purpose
Displays the facility logging severity level
configuration.
Displays the messages in the log file.
Displays the module logging configuration.
Displays the monitor logging configuration.
Displays the messages in the NVRAM log.
Displays the syslog server pending distribution
configuration.
Displays the syslog server pending distribution
configuration differences.
Displays the syslog server configuration.
Displays the logging session status.
Displays the logging status.
Displays the logging time-stamp units configuration.
Default
Enabled at severity level 2
Enabled at severity level 2
Enabled to log:messages at severity level 5
Enabled at severity level 5
Enabled;
Seconds
Disabled
OL-16597-01