Verifying MST Configurations
This example shows how to restart MST on the Ethernet interface on slot 2, port 8:
switch# clear spanning-tree detected-protocol interface ethernet 2/8
Verifying MST Configurations
To display MST configuration information, perform one of the following tasks:
Command
switch# show running-config spanning-tree [all]
switch# show spanning-tree mst [options]
The following example shows how to display current MST configuration:
switch# show spanning-tree mst configuration
% Switch is not in mst mode
Name
Revision
Instance
--------
0
1
OL-16597-01
[mist-attempt]
1
Instances configured 2
Vlans mapped
---------------------------------------------------------------------
1-12,14-41,43-4094
13,42
Purpose
Displays the current spanning tree configuration.
Displays detailed information for the current MST
configuration.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Restarting the Protocol
197