Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 84

Configuring the Switch
Example:
Enter the password for user_name: user-password
Step 6 Enter yes (yes is the default) to create an SNMP read-only community string.
Example:
Configure read-only SNMP community string (yes/no) [n]:yes
SNMP community string: snmp_community
Step 7
Enter a name for the switch.
Note
Example:
Enter the switch name: switch_name
Step 8 Enter yes (yes is the default) to configure out-of-band management and enter the mgmt0 IPv4 address.
Example:
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Mgmt0 IPv4 address: ip_address
Step 9 Enter yes (yes is the default) to configure the IPv4 default gateway (recommended) and enter the IPv4 address
for the default gateway.
Example:
Configure the default-gateway: (yes/no) [y]: yes
IPv4 address of the default-gateway: default_gateway
Step 10 Enter yes (yes is the default) to enable the Telnet service.
Example:
Enable the telnet service? (yes/no) [y]: yes
Step 11 Enter yes (no is the default) to enable the SSH service.
Example:
Enabled SSH service? (yes/no) [n]: yes
a) Enter the SSH key type that you would like to generate.
Example:
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
b) Enter the number of key bits within the specified range.
Example:
Enter the number of key bits? (768 to 2048): 768
Step 12 Enter yes (no is the default) to configure the NTP server and enter the IPv4 address for the NTP server.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
38
The switch name is limited to 32 alphanumeric characters. The default name is "switch".
Configuring the Switch
OL-16597-01