Configuration Guidelines And Limitations; Configuring Call Home; Procedures For Configuring Call Home; Configuring Contact Information - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuration Guidelines and Limitations

Configuration Guidelines and Limitations
Call Home has the following configuration guidelines and limitations:
• If there is no IP connectivity or if the interface in the VRF to the profile destination is down, the switch
• Operates with any SMTP server.

Configuring Call Home

Procedures for Configuring Call Home

Procedure
Step 1 Assign contact information.
Step 2 Configure destination profiles.
Step 3 Associate one or more alert groups to each profile.
Step 4
(Optional) Add additional show commands to the alert groups.
Step 5 Configure transport options.
Step 6 Enable Call Home.
Step 7
(Optional) Test Call Home messages.

Configuring Contact Information

You must configure the e-mail, phone, and street address information for Call Home. You can optionally
configure the contract ID, customer ID, site ID, and switch priority information.
Procedure
Step 1
Step 2
Step 3
Step 4
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
354
cannot send the Call Home message.
Command or Action
switch# configuration terminal
switch(config)# snmp-server
contact sys-contact
switch(config)# callhome
switch(config-callhome)#
email-contact email-address
Purpose
Enters configuration mode.
Configures the SNMP sysContact.
Enters callhome configuration mode.
Configures the e-mail address for the primary person
responsible for the switch. Up to 255 alphanumeric
characters are accepted in e-mail address format.
You can use any valid e-mail address. The address
Note
cannot contain spaces.
Configuring Smart Call Home
OL-16597-01