Reason Codes - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Fibre Channel Interfaces
Operational State
Down
Trunking

Reason Codes

Reason codes are dependent on the operational state of the interface. The following table describes the reason
codes for operational states.
Table 61: Reason Codes for Interface States
Administrative Configuration
Up
Down
Up
If the administrative state is up and the operational state is down, the reason code differs based on the
nonoperational reason code. The table below describes the reason codes for nonoperational states.
Only some of the reason codes are listed in the table.
Note
Table 62: Reason Codes for Nonoperational States
Reason Code (long version)
Link failure or not connected
SFP not present
Initializing
Reconfigure fabric in progress
OL-16597-01
Description
be up, and the interface initialization must be
completed.
Interface cannot transmit or receive (data) traffic.
Interface is operational in TE mode.
Operational Status
Up
Down
Down
Description
The physical layer link is not
operational.
The small form-factor pluggable
(SFP) hardware is not plugged in.
The physical layer link is
operational and the protocol
initialization is in progress.
The fabric is currently being
reconfigured.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Reason Codes
Reason Code
None.
Administratively down. If you
administratively configure an
interface as down, you disable the
interface. No traffic is received or
transmitted.
See the table below.
Applicable Modes
All
All
All
465